Captain’s chest from Sea of Thieves. This is a print in place, functioning chest modelled after the captain’s chest in game. It is sized to print well on an A1 mini. To save print time (~5hours) the jewels are printed separately at .08mm, glue required.

Supports are needed and are manually placed in the print profile. Support for PLA is used with the interface spacing set to 0.  If Support for PLA is not available or not used make sure to reset the support interface spacing to default  value (0.5).Supports are set to normal manual, Tree supports also work well. 

note:  This print profile uses 140g and 4.6hrs if printing in one colour.