Mobile Charging Dock V2

This is an update to the older version.

I have been using the older version for about a week now and I have experienced some issues. I have tried my best to resolve these issues in this version. I am always open for feedback and suggestions if you have any. Please use the comments section and let me know.

Setup Video:

[https://www.tiktok.com/@usmannaeem23/video/7395301024732302608](https://www.tiktok.com/@usmannaeem23/video/7395301024732302608)

Whats new:

This version has a support for the phone stand which prevents the phone from falling backwards. Larger phones like iphone 15 ProMax had this issue. It should be resolved now. I would like to have some feedback if someone uses it for a ProMax phone.
Cable organization has been improved. Specially at the bottom. It is now possible to easily pull/push the phone chargning cable.
It was very hard to swipe from down up on the phone to go to home screen. The screen has clearance now to do the same easily without picking up the phone.

The slicer might say that supports might be needed as there is bridging but I think supports are really not required. I printed mine without any supports. They have been oriented the way they should be in the profiles.

Happy Printing!

Descrição