Get creative and have fun with this 'Days Without Accidents' counter. Also available as ‘DAYS WITHOUT PRINTING’ or any other variente.

Use the MakerLab link and follow these steps:

1. Add your text and position it
2. Go to “Thickness” and increase the height as much as you like
3. Hit download and print as usuall 
4. Enjoy your new counter :)
    

The model uses 6x3mm Neodymium magnets, which are cheap and accessible online. 
Four are needed for the main board, and one additional for each digit piece.

No glue required, just push the Magnets inside the openings at the bottom side of the prints, as seen in the gif.

Add glue to make to make the magnets extra secure. Important when using smaller magnets like 5x2mm or 4x2mm.

Settings

0.4 nozzle
0.2 layer height
AMS optional but recommended for clean text.

No supports.

Filement used

Black Generic PLA
Desert Brown Bambu Lab PLA
Red Generic PLA

Feel free to share your results in the comments!