I didn't like the existing framed HSW, so I designed a full-frame option in Fusion 360. It's a remix of the legendary Rosťa model, and everything is compatible. I personally printed it in Prusa ABS because I had a few unused spools lying around. But it should work fine with PLA, PETG, or ASA as well.

I organized and labeled every plate - don't forget that it's printed upside down. Therefore, the labels refer to where the pieces will be once finished and assembled.

Troubleshooting

Weak adhesion:

• PLA: Remove the top glass and open the door. Switch off the auxiliary fan (the big one on the left side).
• PETG: Make sure your filament is dry, use a 5mm brim with 0.05 gap.
• ABS or ASA: Print with a 10mm brim, 0.05 gap, using Bambu liquid glue stick.

Stringing:

• Make sure your filament is dry (weigh the spool, then dry in oven, reweigh - repeat until weight remains constant).
• Slow down the speed for the outer wall.

 The profile is too big for for A1 mini.