SampleMaster 4-in-1

Introducing the ultimate 4-in-1 filament utility!
Inspired by the need of a better filament sample, the curves of this model helps you to check exactly how it looks when printed.
It attaches directly to the Bambulab filament spools, acting also as a handy label and clip to prevent it to break or tangle.
When that filament is being used it can be clipped to the AMS holder helping you to check each filament type at a glance.
No more guessing the printed look, no more pulling spools off the shelf to read the label, no more broken or tangled filament, and no need to open BambuStudio to check the filaments in the AMS.

Instructions:

- Edit the desired model name in Bambustudio. Go to the "prepare" tab, Click on "objects", right click "text shape", select "edit text" and enter the desired filament name. (some filament names already included)

- Change the filament type assigned to each model.

- Print it with the 0.2mm standard preset with 0% infill. Also "print sequence" is set to "by object" to print up to 3 samples in a single job. They will be printed in sequence avoiding tons of filament changes.

Read carefully:

This model clips perfectly to the Bambulab Spools and have NOT being tested with any other spools brands.

Due to specific printer and filament tolerances, the AMS holder should be inserted in to the AMS carefully to not stress the AMS plastic. If it's hardly sliding in to the AMS holes stop immediately and sand it a little bit.