This a really fun and silly game to play with your friends and family during Easter! Just place the thicker side of the egg in the holder, spin the wheel to see how far down you push the egg, release it, and catch it without it breaking! The last person to break their eggs wins! To prevent unwanted messes(which I think is the best part), you can instead use hard boiled eggs, which should work just fine. IMPORTANT: You MUST print the "egg holder" and "spinner" first, as you are going to pause the "Rocket" mid-way through and place the "egg holder" inside and do the same with the "spinner" and "board game" piece. I also swapped filaments before adding the "spinner" for the "board Game" so that the numbers/letters pop out more. For the "Rocket", I used a paint marker to highlight the numbers and dashes, but this isn't really needed. I'd suggest using a higher infill, more shells, and slower speeds on the "spring' since you want that to be strong and durable. ALSO IMPORTANT: The CAD software I use is sometimes weird with its scaling so in order to fix the model if it comes out very small on your slicer, scale EACH model up to 2540%. I'm sorry, I know it's an inconvenience but the model will still work. Everything should print in 15% infill and 2 shells except for the "spring", with at least 25% infill and 3 shells. The "spring" should be the only thing with supports and it should print fine if you set the automatic support generator to 85 degrees since the flexible part of the spring can print on itself. The filaments used were Creality PLA Hyper Series brown and black and Sunlu's silver silk PLA. If you have any feedback, please let me know so I can try to improve it! Thanks and have fun!