Burj Khalifa

As the largest building in the world, I also wanted to include it in my collection. There are already some models, but I thought I'd give it a try. In the end, it wasn't quite that easy.

In 1:1000, the tower is already quite considerable in size

Printer setting

Extrusion width (over all): 0.4
Perimeter generator: Classic

Support:

Only required below the main entrance roofs at Part 1.

Notes:

The connections might be a little too big, but that depends on the printer. Otherwise, either glue or put some tape around the individual connectors to give them a better fit.

Descrição