Description:

This model is a Scope for nerf blasters. It is styled like a Red-Dot. This will fit any nerf rail. There is no lens or markings printed, but that is for you to make to your choice.

Lens:

As said in the title, this has a custom lens option. There is nothing to print, but rather a DIY craft. (you do not need to follow steps 4+ if you want it to just look cool)

Step 1: Get a plastic container(For mine, I used the clear plastic from a box of blueberries). 

Step 2: Cut out the container until it fits roughly. I'd estimate a 25x25 square to start, and then trim down.

Step 3: Place on your gun. There is a slot on the 3d model where this goes. You may need to use some glue to keep it on. I lost 3 lenses.

Step 4: While looking through the blank scope, shoot a still target until you find a point on the clear lens that is roughly where the bullets hit. My gun was shooting to the side, so I had to put my markings towards the left. All that matters is accuracy.

Step 5: Use a sharpie or other marker to mark where on the lens your dot should go.

Step 6: customize. Around the sharpie, draw a sight that you would like. If you want simple, just put a dot in red or green!

Step 7: Have fun!

Stats/Print Settings:

I printed this on my stock ender 3 v2 and everything was fine. 

NO rafts, supports, or custom settings needed.

Stock Cura Settings works perfect.