Ikea Skadis pegboard mount for the PS5 controller.
It simply just snaps into the slots in the pegboard and is easy to remove if needed. Two vertical hooks keep the mount firmly in place with no movement when accessing the controller. The fit may be a little snug depending on how well your tree supports snap-off.

Print Instruction

PLA or PetG

0.20 layer hight
3 Wall loops

Infill 30% for extra strength
Print modal on its side with tree supports for best results.

Remix

This is a remixed build using over 50% less material and time to print than the original. It is also print in place with no assembly required. Simply print, remove the supports and attach to your Ikea Skadis board ready to use.