This is my second upgrade to A1 3D printer.

I wanted to combine two features: the ability to adjust the camera and a look similar to the company's.

Assembly Instructions

1. Print all 3 parts with supports
2. Print camera cover [https://makerworld.com/en/models/478855#profileId-392195](https://makerworld.com/en/models/478855#profileId-392195)
3. Turn off printer
4. Remove the camera according to the Bambu Lab instructions: [https://wiki.bambulab.com/en/a1-mini/camera-replacement-guide](https://wiki.bambulab.com/en/a1-mini/camera-replacement-guide)
5. Replace the camera with a cover
6. Re-connect the camera cable
7. Insert the camera into the cylinder
8. Insert the cylinder into the body
9. Insert the handle into the cylinder. The handle will keep the cylinder in place
10. Install the module in place of the original cover. Press the latches carefully, paying special attention to the longest one.
11. Attach the original cover

The housing slightly obscures the view of the camera. If it bothers you, then use Extended camera Profile.

Good Luck!