Inspired by @cv6Channel. I need to use side spool for my X1C, but the design shared by @cv6Channel can't fit. So, I decide to design my own version.

Two versions are provided for using PC4-M6 and PC4-M10x0.9 pneumatic connectors. It is highly recommended to use connectors that PTFE tube can go pass all the way through it. That means PC4-M10x0.9 or PC4-M6-4x4, but not PC4-M6-4x2. This will get rid of any unnecessary friction inside the pneumatic connectors.

If you only have PC4-M6-4x2 on hand, you can also try it. But please notice the internal structure of PC4-M6-4x2 might not fit very well for the PTFE tubes come with Bambu X1. This is because the inner diameter of these PTFE tubes are a little bit larger. To solve this problem, you can find other PTFE tube with smaller inner diameter.

About pneumatic connectors:

• PC4-M6-4x4: Threading diameter is 6mm. Through hole diameter is 4mm.
• PC4-M6-4x2: Threading diameter is 6mm. Through hole diameter is 4mm and 2mm.
• PC4-M10x0.9: Threading diameter is 0.907mm. Through hole diameter is 4mm.

Required non-printed parts:

• 4 pcs PC-M6-4x4 or PC4-M10x0.9
• 2 pcs M3x10 screws

Note that support is required for both the overhang and the flat plane inside the output port. Remember to remove the support inside the output port.