This is a Nozzle Changing Tool for Bambu Lab P1P, P1S, X1 & X1C with Bambu Lab Logo

I also changed the Hotend Bracket so you can now mount the complete hotend without removing the fan previously !!

To Disassemble & Assemble a Hotend

1. Mount the whole hotend with 2 screws on the bracket
2. Disassemble the Fan , Silicone Sock, Nozzle clamp, Heater, Sensor 
3. Clean Heater & Sensor (isopropyl alcohol)
4. Remove old Nozzle with Heatbreak !
5. Screw on an new Nozzle with Heatbreak
6. Apply some thermal grease to the top of the nozzle or heater & place the heater
7. Apply some thermal grease to the Sensor & place the sensor
8. Mount the nozzle clamp and pay attention to the cable routing
9. Mount the Silicone Sock
10. Mount the Fan

Now you can mount the Hotend in the printer !!!

Layer height : 0,2, line width : 0,4

Walls 2; top 1,0mm ; bottom 0,6mm

infill 15% ; print time ~ 1h 22min

Sunlu PLA+ Yellow, Bambu Lab PLA Basic Bambu Green

MakerWorld : [https://makerworld.com/en/@sweb3791](https://makerworld.com/en/@sweb3791)

My Models : [https://www.printables.com/de/@CB_384764/models](https://www.printables.com/de/@CB_384764/models)