Do you have too many tablets or little notebooks lying around? This simple divider can hold up to 3 devices on your desk. I have included the F3D and STEP files if you want to make any changes – the Fusion 360 file is parametric!

With a nice wide brim and good build plate adhesion, I was able to print this at a 45 degree angle and no supports for extra layer strength (see photo). However I think that it should be strong enough printed flat on the build plate with an infill pattern like gyroid.

Update July 11, 2024: Added a wider one for more stability. I also included a breakaway fin support for better angled printing. Just snap it off and clean up the small nubs with some flush cutters if needed. You can print this without a brim now.