Hello guys. I wnated to add to my P1S a better control panel. Started with a X-Touch, that is useful and cheap, but later Biqu released Panda Touch. It's a really nice addition, but original mount left cable hanging outside printer, and interferes with my glass riser, so I've decided to design a mount that could cover the wires and interferes with printer design as low as possible.

It's installed over the small cable hole at the top right of the printer with double sided tape. To finish this assembly, you will neet 4 M3 brass inserts for the holes, and 4 screws that are 2mm longer than the original ones. Longer screws with nuts from behind will also do the trick.

Printed mine with 0,6mm nozzle and PA-CF filament only because The color perfectly matches the printer, but any filament can be used.

No supports are needed.