Description

I needed to organize my new AMS... 
At home I had some wooden tables and 2 old tent poles. That's all!

ATTENTION: 
I noticed that my 2 poles have slight proportional differences. So if your case also falls among these, you will have to play around with the percentages a bit. 101% or 102% for example.
In fact, the first pole had a diameter of 20.2mm on the outside and 18.3mm on the inside. The second pole instead is externally 20.6mm and internally 18.5mm. Keep this in mind if you wish to replicate this project of mine.

• PROCESSING PHASES (step by step) attached

- AMS MAGNETIC LOCKING -

The shelf has 33cm height spaces. Minimum and sufficient height to extract and store the reels. I also thought of inserting a magnet into the shelf (⌀20mm hole, neodymium magnet with hole for wood screw, cover cap), and a second smaller magnet inside the AMS handle. This will keep the AMS cover magnetically open during the coil changing phase. This seemed like a useful addition!

- EXTRA WORKING -
While making it, I thought that I might also need light in the future. So I made some grooves with my circular saw (I only had this tool at home), and I inserted 40cm aluminum profiles embedded in the wood. Subsequently equipped with 3000°K white COB LED stripes (I'm not interested in RGB). The cables were inserted into a cavity on the edge of the shelf, and a small quick connector added to the back of the shelf. So as to facilitate any maintenance. The white LED power cables, all connected in parallel, can be seen in the photo in the rear corner.

I decided to leave the PTFE tubes with soft curves.
I just wrapped them together with special rings (see photo).

Disclaimer:

This work by TheMiguelBi is licensed under Standard Digital File License

Strict non-commercial, personal use only license.

You are not allowed to Remix or Copy this model to other 3D printing websites without my permission.