Annoying Pac-Man Ghost

*Added another print profile Including the jail, edited some titles to profiles for easy understanding*

The Annoying Pac-Man Ghost!

Transported in a handy jail cell, this playful model is inspired by a classic prank. Set it out and watch as someone discovers they need to pick up 10 nested items instead of just one! The lid of the cell doubles as a spatula, perfect for sliding the ghosts onto a table or, even better, the floor, ensuring the challenge remains.

The largest ghost measures 50.60mm (roughly 2 inches) and the smallest ghost measures 6.60mm (roughly 1/4 inch).

For best results, I highly recommend printing this model with a brim due to the small connection points to the print bed. Some general cleanup of the brim will be necessary after printing.

Overall, this print is a joy to watch people interact with, as they uncover just how many tiny ghosts are hidden inside. It's sure to bring laughs and surprise to anyone who encounters it!

Print Settings for Ghost

I have provided the recommended print method for the ghost in a profile. If you prefer to set it up yourself, here are my settings. Feel free to customize the colors as you like!

Supports for Ghost: No
Brim: Yes (inside and outside)
Infill: 15% preferred (If you encounter an issue with a ghost not being flat, change the infill to 20% and slice, then back to 15% and slice again. This will fix the issue and it will print correctly. Looking forward to Bambu fixing this glitch)

All other settings can be left at default or adjusted to your personal preferences.

Print Settings for Jail Cell

I print the cell with the bottom of the cell on the build plate and the bottom of the lid flat on the build plate. This setup eliminates the need for support for the lid.

Supports for Cell: Yes
Brim: Yes, preferred on the outside, but it will print fine without one
Infill: 15% preferred

Descrição