A simple, tiny, and easy to print case for the RAKwireless Meshtastic Starter Kit (RAK19007 baseboard with RAK 4630 or 4631 LoRa module).

This case is inspired by MeshtasticCmoi's, which I liked a lot but it didn't fit the components. A built a similar one from scratch and turned the board around, so the power connectors would clear and allow for a even more compact form factor.

You will need two (2) M2x8mm socket caps screws (the black ones that come with the kit might fit in a pinch but they are a bit short).

The case fits the linked LiPo battery, 500 mAh (dimensions 5 x 25 x 35 mm). I assume a slightly larger battery might fit as well.

Make sure the contacts have the correct polarity, I needed to switch mine around - easy to do with a small screw driver by pressing down the hooks that keep the contacts in place.

It prints without support, but the USB-C connector opening looks better with.

Features:

- slots for antennas

- well-aligned opening for USB-C connector

- holes for reset switch and LEDs

Final dimensions:

Width: 40 mm / 1.57 in

Depth: 64 mm / 2.52 in

Height: 18 mm / 0.71 in

The model in the picture was printed in PLA matte black. AA battery for scale - Did not have a banana :/

------- EDIT: Adding a larger battery model (1000 mAh) -------

The larger case fits this LiPo battery, 1000 mAh (dimensions 5 x 34 x 50 mm). Again, remember to check polarity before connecting it - I needed to switch mine around.