Changelogs

Version 2

Added version 2 and updated print profiles.
V2 version makes sure that Container and Lid wall pattern match when they are connected.
-Geometry generation in V2 can take more time than in V1
- In V2, the wall pattern size can slighlty change with changed outer diameter 

Print settings

Print each model with default settings - 0.20mm Standard print profile.

Description of main parameters

Outer_diameter 
Height
Lid_height

Container height to lid disabled vs enabled

Lock_strength_modifier - Add approximatelly 0.05 or more to make lock stronger, or -0.05 or less to make lock weaker. You can enable Cut_preview to see impact

Important to know

The way how lock mechanism clicks is affected by many dimensions and print configurations. Parameters like material type, material vendor, Outer diameter dimension, thickness, wall pattern, print settings… Even the same configuartion after changed flow calibartion can lead into different results. Believe my, I did many tests to check this.

I did my best to make calculations to generate proper geometry. However it may happen that for some of your configuration the click mechanism might not work as expected. In such case you can adapt the Lock_strength_modifier parameter and try to print the container again.