I've played around with a bunch of DIY slim wallets and never found one that I 100% loved so I made my own. I don't know if this one will be that for you but it checks all the boxes that I was looking for. Printed fully from PLA. There are two different face plates. They are interchangable so you can run with the cash clip or without or with two if you'd like. The cash stops drop in from the backside of the face plate and I just put a drop of superglue on each end of the stop. As for the clip, just snap it in and put a few drops of super glue on the inside. The face plates snap in pretty well into the frame without glue but I recommend a tiny drop on each pin just so it doesn't pop apart by accident. I also included a thinner frame if you want to carry less cards than I do. No supports used at all for the prints. Hope you enjoy.