The Design

You Asked for it, its here!

The new Stackable impossible passthrough!

Fully compatible with the V2 Series,

The “male” part of the thread seems to defy physics by passing through the slightly larger “female” Part

Now your can print as many tall parts as you like and add them together to make an extra long vortex tube!

The Ball Twists its way down the Tube

There is a Top cap and a Bottom cap to prevent the the ball escaping

Or, if you've got a spring from a ball point pen lying around, try adding this into the centre!

Dimensions of 1 tall part is approximately: diameter 32mm x 60mm

Let me know if you experience any issues.

If you enjoy this print consider giving it a boost (It'd really help me out!)

Printing

Ensure Auto Tree supports with 30 degree angle is used (to support the top section of the tall piece)

The ball is “floating” to ensure the best lower surface possible. use auto tree supports to an angle of 30 degrees

It is set up to print sequentially, it is very tight on the print bed, if you have any issues i suggest you split into separate plates.

Once printed let the build plate cool before trying to remove.

My Work

After many years in Engineering, I've just decided to try and follow my childhood dream of becoming of a Creative Designer.

A Creative Designer of what? No idea! Right now I really like puzzles, mechanisms and kinetic sculptures so that's where I'm going to focus my efforts.

Or you can join my Patreon for More Exclusive Designs here: 

[https://www.patreon.com/RJ_Design](https://www.patreon.com/RJ_Design)