Only .08gram of Supports needed(For teeth)!

I've been eyeing this model for a while. I really wanted to have a dice tower with a dragon on it but the original model was slam full of supports as every spine on the dragon was pointed down and the dragon wasn't really connected to the tower much at all. I readjusted all spines to point upward, angled head/neck up, gave him a tiny bit of battle damage on the wing, pushed the dragon around until is was connected at all lower points to the tower to totally remove the need for any supports on the dragon. Only the teeth need supports.

Putting together an AMS version for this but its a ridiculous amount of waste due to its height. I'd recommend just hand painting it like I did in the photos. 

***Updated 04/25***  

V2 Print Profile

Revisiting for overall improvements:

• Strengthened wing connections to towers
• Connected remaining sections that were floating
• Improved Supportless printing -  except for teeth
• Dragon face lift 
  • Added 200,000 triangles to smooth out textures. 
  • Improved Wing definition and structure
  • Took away battle damage hole in the wing (too many complaints about a hole)
  • Touch up some features on face and body
    • Now he Purdy