Modular Display

PLEASE CHECK OUT OUR UPDATED V2 MINI DISPLAY- IT USES LESS MAGNETS- AND IS FULLY COMPATIBLE WITH OUR OTHER MODULAR DISPLAYS.

This originally was going to be a modular standing display for small toys or other small items. While this worked great for that purpose, I ended up needing a way to better display all of our tiny prints that we sell at shows. This has worked perfectly for us, especially with the magnets helping them stay in place even when 1000's of people are digging through them.

These fit great in Polymaker boxes, so you can recycle those, or you can use the LID profile if you would rather have a lid for storage.

I used 12mm x 2mm magnets, MAKE SURE THEY ARE GOOD AND STRONG MAGNETS before gluing them in. The best magnets I found were on Magnet Baron. I did the negative space in BS in case you want to mod that for a different size. It is a good snug fit so make sure your printer is dialed in. Mine fit perfect with the profile I used with Matte PLA.

There are 12 plates with several purposes

Plate 1- single box with no magnet
Plate 2 single box with 4 magnets for ones that are going to be in the center
Plate 3 single box 3 magnets for corner pieces
Plate 4 single box 3 magnets for front middle pieces
Plate 5 quad box with no magnets
Plate 6 quad box 4 magnets for the corner
Plate 7 quad box with magnets on all sides for middle pieces
Plate 8 quad box with six magnets for center front pieces
Plate 9 two boxes 3 sided for middle section
Plate 10 two boxes two sided for left side
Plate 11 two boxes two sided for right side
Plate 12 two boxes no magnets

Check out our large version HERE:

We have a lot of great stuff over at the Patreon: [https://www.patreon.com/WilliamsIndustries](https://www.patreon.com/WilliamsIndustries)

We release about 30 files a month. Patreon membership includes commercial use on all prints.

Descrição