Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm
Filaments Used:
PLA BambuLab Basic BambuLab Green Transmission Distance: 2
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 6 unique filaments. Substitute as needed.
Swap Instructions:
Start with BambuLab Green
At layer #5 (0.48mm) swap to Yellow
At layer #13 (1.12mm) swap to Black
At layer #18 (1.52mm) swap to Blue Gray
At layer #20 (1.68mm) swap to Gray
At layer #23 (1.92mm) swap to Jade White for the rest.
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta