Introduction

The original model is designed for printers with a 250x250mm bed.

If for any reason it doesn't fit on your bed, you can resize the model to the size you want from your slicer.

It consists of two parts, the lamp body (body.3mf) and the rear cover (lid.3mf).

Sometimes I include two lids, with and without a hole (choose the one you want, I recommend printing the Lid with hole whenever possible, to be able to remove the LED cable).

If the back cover does not have a hole, you can easily make it from Bambu Studio, or from any other slicer you use.

----

You will need

• LED Strip: [https://s.click.aliexpress.com/e/_DekFgj1](https://s.click.aliexpress.com/e/_DekFgj1)
• - Glue gun or Tape

Optional, but recommended:

• Aluminum tape: [https://s.click.aliexpress.com/e/_DEPgqHd](https://s.click.aliexpress.com/e/_DEPgqHd)
• - Textured PEI Sheet

----

Assembly instructions

You can follow either of these two videos to assemble the lamp. It's very simple, you stick the LED strip inside and that's it. If you want, you can use aluminum tape to improve the lighting, although it is not necessary:

• Assembly instructions by braga3dprint: [https://www.youtube.com/watch?v=QNsShLmXYh0](https://www.youtube.com/watch?v=QNsShLmXYh0) (He makes very beautiful designs, you can leave him a follow and help him grow his channel!)
• - Another assembly instructions: [https://www.youtube.com/watch?v=nDUlBp7Mm1c----](https://www.youtube.com/watch?v=nDUlBp7Mm1c----)

----

Printing settings

Following braga3dprint recommendations, you can start with these settings in Bambu Studio:

• Preferences (CTRL + P) → Activate developer settings → Quality → Advanced → First Layer Flow Ratio: 1.04
• - Quality → Wall generator → Arachne
• - Quality → Wall transitioning threshold angle → 50 degrees
• - Strength → Advanced → Infill/wall overlap → 20%
• - Quality → Advanced → Avoid crossing walls
• - Increasing retraction / reducing temperature can help reducing wisps
• - Order color printing from lightest to darkest color

Important!

Remember to remove the purge line at the start printing, otherwhise it will ruin the print.

Adjust the sequence of colors from Light colors to Dark colors, to prevent stringing.