This print is specifically designed for the basic WiFi board straight out of the box, omitting features such as the antenna and SD card slot.

This creation is a remix of magdong's Wi-Fi Dev Board Case ([https://www.thingiverse.com/thing:5564906](https://www.thingiverse.com/thing:5564906)).

For secure assembly, utilize 4 x M3x12mm screws accompanied by 4 x M3 nuts.

This design also has a pin protector boot cover that can be found in the following locations:

• [https://www.printables.com/model/606861](https://www.printables.com/model/606861)
• [https://www.thingiverse.com/thing:6104552](https://www.thingiverse.com/thing:6104552)
• [https://github.com/CodyTolene/3D-Printing/tree/main/Flipper%20Zero%20-%20WiFi%20Dev%20Board%20Case%20Boot%20Cover](https://github.com/CodyTolene/3D-Printing/tree/main/Flipper%20Zero%20-%20WiFi%20Dev%20Board%20Case%20Boot%20Cover)

My print settings:

- Hatchbox PLA
- 0.2mm layer height
- 0.4mm nozzle (line width)
- Enable retraction
- Wall count 3 (+ print thin walls enabled)
- Top/bottom layers: 4
- Infill density: 20%
- Infill pattern: Cubic
- Print temp 200 C
- Bed temp 60 C
- No supports needed

See more designs on my GitHub here: [https://github.com/CodyTolene/3D-Printing](https://github.com/CodyTolene/3D-Printing)