A simple Playdate magnetic cover with felt inlay.

Magnets holds the Playdate in place and protects it, making it easy to remove and insert into the case.

Currently the with all the magnets installed the crank does not work, while the playdate is in the case. You can use one less magnet at the lower right side of the bottom case to allow use of the crank, but the case would not close as securely.

Needed materials:

• 10: 10x3 Round magnets
• 17.5cm x 7.6cm x 0.3cm: Felt Fabric
• A 3D printer or 3D printer service
• Glue or adhesive to keep the magnets and fabric in place
  

It can be printed in around 2.5 hours at 0.2mm layer height and takes around 35g of filament with 15% infill.