BUILD YOUR BIG DIAMOND 

无需支撑打印。

No support needed.

超大3D打印钻戒。使用透明PETG材料打印钻石,无需支撑。使用简单嵌入结构，保证装配简单。

Large 3D printed diamond ring. Use transparent PETG material to print diamonds without support. Easy assembly with simple embedded structure.

打印配置:
全部使用PETG进行打印.
标准PETG参数 ：0.2层高 2层墙 15%填充。
无需支撑 ! (如果出现不沾板的问题时候，清洁你的打印板 !!) 

Print settings:
Printed everything in PETG.
standard generic petg settings 0.2 layer height 2 walls 15% infill.
no support needed ! (when having adhesion problems: CLEAN your plate !! )

下面是diamond1结构成品图。

The following is the diamond1 structure diagram.

你也可以使用BambuStudio切片软件对模型整体自由进行缩放，他也可以正常打印工作。下面是缩放至手指合适大小照片。

You can also use BambuStudio software to scale the whole model freely, and it can print normally. Below are photos scaled to fit your finger.

EXTRA:

diamond2模型配置打印高层效果不好，如果你喜欢diamond2，也可以考虑挑战一下修改打印参数来打出漂亮的模型。

Diamond2 printing high-rise effect is not good.If you like to diamond2, you can also consider the challenge of modifying the print parameters to produce a beautiful model.