为热靴而设计的瞄准镜模型

（非现实型号，你可以修改轨道，另作他用）

瞄准镜本体和配套的热靴盖是通过摩擦固定

热靴盖组件是参考sony相机原厂设计

透明镜片效果使用透明塑料片、透明胶带对粘都可以实现，裁成对应大小后和打印的固定片粘上，再用胶水粘上主体

最后实现红色的点的效果，用红笔点一下即可

摩擦组合常见问题

一开始很紧，随着拆装产生损耗，间隙变大会更松

若太紧；可以适当打磨接触面

若太松；可以贴薄胶布在接触面

源文件已放出，f3d格式，使用fusion360可以编辑

Model of a Hot Shoe-Mounted Sight

(This is a non-realistic model. You can modify the rail for other uses.)

The main body of the sight and the accompanying hot shoe cover are fixed by friction.

The hot shoe cover component is designed based on the original Sony camera design.

For the transparent lens effect, you can use transparent plastic sheets or transparent tape stuck together. Cut them to the appropriate size, attach them to the printed fixing piece, and then glue them to the main body.

To achieve the red dot effect, simply use a red pen to mark a dot.

Common Issues with Friction Assembly

Initially, the fit may be very tight, but with repeated assembly and disassembly, wear will increase the gap, causing it to become looser.

If it is too tight, you can appropriately sand the contact surfaces.

If it is too loose, you can apply thin adhesive tape to the contact surfaces.

Source file released in f3d format, editable with Fusion 360.