Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can adjust the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Brown Transmission Distance: 2
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4
This print uses 6 unique filaments. Substitute as needed.
Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Blue Gray
At layer #10 (0.88mm) swap to Brown
At layer #11 (0.96mm) swap to Gray
At layer #15 (1.28mm) swap to Orange
At layer #24 (2mm) swap to Red for the rest.
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta