EDIT:  This didn't happen before (when the model was first published), but it seems that if you scale it to 200%, you get this weird artifact when switching from red to white stripe (around layer 580ish).  It never used to do this, but for someone reason when the slicer scales it up, it creates this little error.  Proceed with caution if scaling to 200%.

The American flag! You will need a multicolor printer for this model. I would not scale it any (or much) smaller, because then the stars may not print well. If you are going to increase the scale, I would decrease the amount of walls in the print profile, so it doesnt print solid - to save some filament. Enjoy!

If you would like a merchant license to sell this model/print, please private message me. Thanks!

Or send me a tip! Venmo: @dfreshkremer (0818)