Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can adjust X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 2.5
PLA BambuLab Basic Gray Transmission Distance: 3
PLA BambuLab Basic White Transmission Distance: 6
This print uses 4 unique filaments. You can substitute to your needs.
Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Blue Gray
At layer #14 (1.2mm) swap to Gray
At layer #21 (1.76mm) swap to White for the rest.
