Coat Hanger

Hey,
this is a coat hanger. You can use it for most types of hangers to hang up coat, shirts or pullovers.
This model is inspired by this: [https://makerworld.com/en/models/471010?from=search#profileId-380621](https://makerworld.com/en/models/471010?from=search#profileId-380621)

If you like my model, consider boosting it, thanks!

Have fun!

Disclaimer / Terms of Use

Use at Your Own Risk: This design is provided "as is" for hobbyist purposes only. I am not a professional engineer and shall not be held liable for any damages (property damage or personal injury) resulting from the use or failure of this model.
Material Selection & Preparation: You are responsible for choosing the correct filament (e.g., heat-resistant or flame-retardant) for your specific application. Ensure that the filament is completely dry before printing. For maximum structural integrity and mechanical strength, it is necessary to use a freshly unpacked, new spool of filament.
Electronics Warning: When used in combination with electronics, ensure proper insulation and adequate ventilation. Do not use this model with electrical voltage unless you are a certified professional.
No Warranty: I cannot guarantee the mechanical strength or dimensional accuracy of the print, as 3D printing results vary significantly depending on the printer, calibration, and individual settings.