(A1 MINI VERSION IN MY OTHER MODELS)

During this upgrade, some parts of your printer may be damaged, I am not responsible for any damage caused by incorrect installation or other damage. If your cables appears too short for this mod you should not install it.

Another version of camera relocator, this time you can adjust the angle of the camera!

INSTRUCTION:

Print all 3 models as they are in print profile, camera holder should be printed with supports

DURING NEXT OPERATIONS THE PRINTER SHOULD BE TURNED OFF!

Remove original faceplace and camera according to BambuLab instruction

Push camera into it's new holder, it's supposed to be pretty tight so vibrations won't make any noise

Put new faceplate on the X-axis with the cable going through a hole and carefully bend the connector 90 degrees, it'll be easier to connect it.

Push the cable through camera holder hole and connect it.

Push in the camera facing down and rotate it so it locks

Put the back cover and adjust the angle