If you're like me and want a quicker way of cleaning your solder tips (or just want to look cool) and also don't want to spend a lot of money then you're at the right place! I designed and built this for around $30! Note that the bezel template is meant for you to trace out the size bezel you need on a piece of metal. The metal isn't required, but makes the overall appearance look nicer.  I have sinse upgraded it by adding a foot switch that can be found here: [https://a.co/d/1CYCiyW](https://a.co/d/1CYCiyW).  Instead of running the wires to the button run them to the switch.

You will need to purchase the following items:
-Female DC Power Jack
[https://a.co/d/8S8UQew](https://a.co/d/8S8UQew)
-380 DC Motor
[https://a.co/d/5b54DNG](https://a.co/d/5b54DNG)
-Flange Shaft Coupling*
[https://a.co/d/0HllmMc](https://a.co/d/0HllmMc)
-3mm Shaft
[https://a.co/d/eP7XqJT](https://a.co/d/eP7XqJT)
-6700-2RS Bearings
[https://a.co/d/9oDhS6M](https://a.co/d/9oDhS6M)
-Tactile Push Button
[https://a.co/d/8mwvuzs](https://a.co/d/8mwvuzs)
-22ga Wire
[https://a.co/d/eaielpp](https://a.co/d/eaielpp)
-Rubber Belt
[https://a.co/d/fNsJyZa](https://a.co/d/fNsJyZa)
-25mm Brass Wire Brushes**
[https://a.co/d/6RgUcoo](https://a.co/d/6RgUcoo)
-3x2mm Magnets
[https://a.co/d/5QLbnt3](https://a.co/d/5QLbnt3)
-693ZZ Bearings
[https://a.co/d/h8jFAMM](https://a.co/d/h8jFAMM)
-6700-2RS Bearings
[https://a.co/d/dDdMkAI](https://a.co/d/dDdMkAI)

-Just about any 12VDC power adapter will work.

*Shaft diameter will depend on the diameter of your brush handle diameter.
**To save money you can make your own brushes using a cotter pin and a dental burr cleaner
[https://www.aliexpress.us/item/2251832732435290.html](https://www.aliexpress.us/item/2251832732435290.html)