jawbone headset + headphone stand

This is a headphone stand specifically designed for a headphone and a jawbone headset. It is a two piece install, base and stand which just fit together on first try. No glue necessarily required.

printed flat on print bed so lines would be vertical standing up thus enabling it to not snap as easily.

support: whatever the Cura slicer gave me (very minimal, mainly for the block at the end of the stand that I made 100% infill and used support to lift up)

infill: played it safe, did 20%

3d printer: Creality CR10-mini

time: about 4 hours each (stand and base) with all the default settings

p.s I shortened the width of the big headphone holder so that it won't be allowed to slide as far out

Descrição