I had some LED filaments left after making xbox controller stand for a friend and decided to use them.

This is a remix of PS5 dualsense controller stand by La Guía del Mando mixed with a popular Xbox controller stand with LED by agepbiz.

All the hardware is the same as for Xbox controller stand.

Agepbiz did a great job on the instructional video, so here is a link if anyone should need it - [https://www.youtube.com/watch?v=e6Gn6LNSfcg](https://www.youtube.com/watch?v=e6Gn6LNSfcg)

The only thing I did differently to speed up the soldering process was to skip the wire indicated on the photo below.

Instead, I just did this:

Hardware
Links to the LEDs and Batterybox I used in this project (not affiliated). Some items have several options, make sure to select the correct size.

300mm 3V LED Filament: [https://www.aliexpress.com/item/1005003775632413.html](https://www.aliexpress.com/item/1005003775632413.html)

2x1.5V Batterybox with switch: [https://www.aliexpress.com/item/1005003517942515.html](https://www.aliexpress.com/item/1005003517942515.html)

8x2 Rubber Pads: [https://www.aliexpress.com/item/1005005297036433.html](https://www.aliexpress.com/item/1005005297036433.html)

For the wires you can use whatever small cross section you've got at hand.
I used something similar to this, 30AWG: [https://www.aliexpress.com/item/1005001626937991.html](https://www.aliexpress.com/item/1005001626937991.html)

Print settings

• No raft
• 15 Bottom Shells to minimize light leak
• Support Structures where the batterybox will be attached. Avoid Supports where the LED groove is 0,1-0,2mm layer height