Squishy Gyroid Pad

Remove all walls, top and bottom layers, and infill density, switch the infill to gyroid, or whatever you like, and print with TPU for a super squishy and satisfying pad!

Also, check out our newest squishy, a Donut: [https://makerworld.com/en/models/763665#profileId-698646](https://makerworld.com/en/models/763665#profileId-698646)

Print settings:

Wall line count: 0

Top layers: 0

(You only want infill, so remove all top and bottom layers and walls)

Infill Density: 10%

(You can raise this for more thickness and resistance or lower it for more squishiness and higher visibility of the pattern)

Infill Pattern: Gyroid

(You can try other patterns as well!)

Make sure you have no gradual infill steps or the infill will increase in density when it gets to the top of the print.

Print speed: Doesn't matter, just not too crazy because the travel speed is affected by it.

Infill speed: 30mm/s

Initial layer speed/Infill initial layer speed: 15mm/s

(The infill speeds are the only things that really matter, because that is all you are printing; however, make sure to set them very low, because TPU needs slow speeds for printing)

Here is an example of the settings in cura:

Here is an example of the settings in Bambu Studio:

Speeds:

Descrição