For this remix I sliced off the bottom of a gridfinity USB storage design and added the bottom of the gridfinity with pin design instead to make it compatible. Note that the USB sticks are not a tight fit but have a little slack so they go in easily.

The holder is still 100% compatible with standard gridfinity bases but the gridfinity with pin allows it to click into place. No magnets required.

The base is here:

[https://makerworld.com/en/models/440624#profileId-346300](https://makerworld.com/en/models/440624#profileId-346300)

See here for a collection of gridifinity with pin designs put together by One Maker Show the designer of this system:

[https://makerworld.com/en/@OneMakerShow/collections/1143270](https://makerworld.com/en/@OneMakerShow/collections/1143270)

Print Instructions

• Filament : PLA works really well I've not found a need for stronger, but you could use anything
• Infill: As per profile works great but you can easily reduce it by a few percent as nothing is under stress with this
• Drying: Always well worth drying your filament whatever it is, you will get better results with dry filament!