Edit: thanks @RoboCZ for his print profile for printers with AMS!

Just a cute fat hamster with some space inside! Use it as a gift box or hide your favourite candy inside :)

Print in place, no supports. You can print both parts at once.

Scaling: Don’t forget to scale both parts equally. There is enough tollerance for the thread to work fine. I recommend at least 50% size, but I tried 40% and it worked too. The yellow hamster on the picture is about 55mm high, with scaling down to 55%.

You can use the “paint seam” tool to paint the seam on the back, or use the settings (seam position: Rear).

I made 2 options for the bottom part:

1. with the feet - I don’t guarantee that the face will be aligned parfectly with the feet - depending on the printer and size (and how strongly you close the thread), the feet might be a little bit on the right/left side
2. without the feet - if you cannot stand the fact in point 1., print it without the feet, there’s nothing to align :)

Layer height: For the smallest one (40% scale) I used 0.1 mm layer height. For bigger ones (50% and bigger) I used 0.15 mm.