I'm a skull lover and I needed a place to put my remotes so I wouldn't lose them, so I combined both things. I took an incredible skull published on this same page to make a remix and turned it into the ideal support for my controls.. I added a couple of holes to the skull to place the remotes, and made a base so that the skull wouldn't tip over with the weight of them.

Note 01: In the files I left other versions in case you want the controls to be placed horizontally instead of vertically, one with an opening (SKULL_02) and one without an opening (SKULL_03).

Note 02: I have not printed the versions for the horizontal placement of the remotes (SKULL_02 and SKULL_03), so I cannot ensure their correct printing. If you print them, I would appreciate it if you would share photos to see the final result.

Note 03: SKULL_02 and SKULL_03 need the base marked especially for these two variants, check carefully which base each skull will be printed with.

Note 04: I'm sorry if my English is not good enough XD