Amp up your tabletop gameplay with this themed interactive dice tower. This tower features a mechanical plunger that will launch your dice into the tray. It requires no supports to print, and no external hardware to assemble.

To use, simply insert dice at the top, lift the handle, and push it back down.

Features a springless ratcheting freewheel mechanism so that the dice only launch when the plunger is depressed, not when raised.

No AMS/MMU Required:

Designed to be broken up into multiple plates for multiple colors.

Assembly Instructions:

1. Insert Handle into the appropriate hole in the Detonator Box.

2. Flip upside down, and line up the Receiver with the teeth on the Handle, insert and twist until seated.

3. Run the Receiver and Handle up and down a few times to work out any extra friction.

4. Examine the Pawls to find the chamfer (Left pawl in picture below shows the chamfer).

5. Insert the pawls, chamfer side first onto the matching axels on the Freewheel. There will be an audible click when it is fully in place.

6. Make sure the pawls move freely on their axels. If any pawls are stiff first make sure it is fully seated on the axel and wiggle it around until loose.

7. Insert the Freewheel into the hex opening on the Receiver.

8. Place the Agitator disc over the Receiver as shown.

9. Snap the Base Plate into place, lining up the snap lines, and axel for the Freewheel.

10. Flip back over, and insert the Fuse Leads.

11. Snap the Band over the Dynamite Tray.

11. Cut 3 pieces of black filament to desired length. The length is purely aesthetic preference.

12. Insert or glue filament into the Dynamite Tray, trying to make the opposite ends meet.

13. Insert or glue filament into the Fuse Bundler.

Note:

Works best on a no slip surface, as the dice can be launched hard enough to make the tray slide.