This is a case for the Lilygo T-beam meshtastic radio. It's designed with three buttons and easy access to the charging port. It sits nicely on a desk, car dashboard, or any flat surface.

The lilygo t-beam slides onto the rear pins of the “front” piece, after the buttons have been placed in their holes. Then the back piece slides down over the top and clicks into place. You need to hold your lilygo t-beam forwards for the final click into place, as the body piece presses the board forward.

Please Note - there are pins at the bottom of the front portion of the case, the lilygo t-beam should click down onto those little pins. This is how you get the most secure mounting. The easiest way to get the lilygo t-beam onto those pins is to angle the t-beam towards the back, then push in at an angle (as per the included photo). When it snaps in, it will sit flush with the front supports.

It can be printed in PETG or PLA, multi-colour or one colour.

Please do not print and sell this design. I'm providing it for free for the meshtastic community.