I saw many different designs for Lithophane stands and globes ect. I wanted something I could plug in. I designed this stand to allow me to customize my needs. It's very basic and easy to print and gets the job done.

For the Stand:
For the lighting I choose to use strip LED's of 5v - s://www.amazon.com/gp/product/B08M65DKZ7/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1

For the connector I used a USB-C type connector. You can then use an old phone charge or a battery recharge pack to power it. For this one you may need to trim the corners of the board off to get it in snuggly so it will not move.
[https://www.amazon.com/gp/product/B09KC1SMGD/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1](https://www.amazon.com/gp/product/B09KC1SMGD/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1)

A little solder and wire and you are good to go.

Any questions or suggestions please let me know.

If you decide to redesign it please tag it as a remix and show me what you did.

Any suggestions for improvements please let me know.

For the Globe:
I used Lithophane Maker-
[https://lithophanemaker.com/index.html](https://lithophanemaker.com/index.html)

I used these settings:
Lithophane Resolution: 0.25
Sphere Diameter: 100
Picture Angular Height: 90
Picture Angular Width: 120
Maximum Thickness: 2.4
Minimum Thickness: .6
Cylinder Outer Diameter: 40
Cylinder Height: 10
Cylinder Thickness: 5
Cylinder Ledge Outer Diameter: 55
Top Hole Outer Diameter: 0