tested material: PETG and PLA

layer height: 0,2mm

infill 15%, wall count: 3

no support needed

Tested on A1

!!!!

PETG print quality is the best if the minimum layer time is 12sec (default for generic petg profile). As you lay down multiple parts, the printing speed is increasing, so I recommend to multiple the minimum layer time with the number of prints. So if you print 3pieces, you have to set the min layer time to 36sec. Otherwise the arc quality will be bad.

Furthermore the seams must be in the marked place. (see documentation)

Different materials and printers maybe can print with different settings than above.

You have to insert a 3mm outer diamater tube to the center of the hole for fishing line.