Fully 3D printed hula dancer for your dash!

If you plan to put in your car DONT USE PLA! It will melt on a hot day

To assemble:

• Print all 4 models
• remove supports from the top model
• use an x-acto knife to remove the support wall from the grass skirt
• insert the spring into the legs and into the bottom of the grass skirt
• insert the top onto the grass skirt using
• use a hot air gun (or hairdryer) to melt the strings of the skirt down to make the grass

Original model was remixed by seperating into several pieces, recreating the grass skirt, and adding a spring to create the dancing effect

Original: [https://free3d.com/3d-model/huladancer-v1--759698.html](https://free3d.com/3d-model/huladancer-v1--759698.html)