This is a configurable coat hook. You can stick the 48mm version onto the side of an Ikea Kallax using Tesa Powerstrips and create a coat hanger for your kids.

Hint: To get all versions as STL, use “Download STL” above.

If you could take a picture of an actual print, please "comment" and attach the picture. - I am curious to see your uses in the wild!

You can configure (Either by using OpenSCAD and the customizing instructions here or by the Thingiverse Customizer):

• The number of hooks and their distance
• The width of the hook, the hooks angle and tip radius
• The width of the corner the hook is attached to, the thickness of the corner

The printing orientation

• a single hook works "on the side" without support material / raft if you have good adhesion.
• "45 degrees" might need some support material and a raft, but is probably the only choice if you have more than 2 hooks

Print instructions

You can print it without support.