A smaller version of Simple Indoor Glider v2 with increased stability, easier elevator folding, and more control of the flight.

Profile is for PLA on the p1/x1 series. 17 minute print with under 5 grams of filament. Do not bend or warp wings while removing from the build plate.

Thrown from below the head of the glider like a dart. More control means more room for error, but also adds the ability to add a predetermined curve to the flight. It should fly straight if thrown straight like a dart, but curve in the direction it was curve thrown in. It should also maintain its tilt for some time before leveling out. Combining curve throws and tilts will make an interesting pattern. As for throw strength, it can be medium to hard as long as it is thrown straight.

Instructions: Fold the elevators 35 to 45 degrees up from the downwards facing side of the head. Then fold the stabilizers 90 degrees up relative to the downward-facing head. The weight of the head must be facing downward relative to the elevators and stabilizers when thrown.