This button is an adaptation of my AMS button with a flexible riser. [https://makerworld.com/en/models/431315#profileId-335839](https://makerworld.com/en/models/431315#profileId-335839) I realized that not everyone wants that feature so I adapted the design to be a button that is easy to secure and uses very little material. A small piece of sacrificial PTFE is optional to reduce the wear.

To install the button, tilt slightly and secure the back lip over the original AMS feeder button. Then rock forward and press down until the front lip of the help button clicks under the front edge of the AMS feeder funnel. The button should be secure if you give it a wiggle. I have tested this on both old and new version of the AMS but I have NOT tested with the Hydra mods.

If you like this please feel free to check out my other models. Feedback is always appreciated.

[https://makerworld.com/en/@Just_Josh](https://makerworld.com/en/@Just_Josh)