This is a replacement frame for Rayban Aviator lenses (in case your original frame has been damaged). Filament (1.75mm) is used as pin for the hinge. You can use hot water or a heat gun (with caution) if you cannot insert the lenses. The same way you can modify the curve of the temples if you are not satisfied with the fitting.

Print instructions

Category: Glasses Print Settings

Printer Brand: Prusa

Printer: Prusa Mk2

Supports: Yes

Notes:

For the best printing result it is advised to use PVA for support material. Otherwise, it is important to use the suggested settings below.

Cura Settings (for the frame)
Layer Hight : 0.1mm ( or 0.06mm)
Support : Yes
Support Density : 20%
Support Z Distance : 0.2mm
Support Horizontal Expansion : 0.5mm
Enable Support Interface : Yes
Support Interface Thickness : 0.4mm
Support Interface Density : 100%
Brim : 1mm (for the frame, if you have adhesion problems)

Post-Printing

Use a piece of filament (1.75mm) as a pin.