I'm loving my Playdate so I designed a small minimal case for it.

There are three files, a bottom case file and then two top options - one with a graphic of the playdate and the other is a blank.

Parts you'll need:

2x M3 Screws 12mm+ (for the hinge)

1x Craft Foam

2x 6 by 3mm magnets

Some glue

1. print your parts
2. I designed the top to use a craft foam insert to protect the screen
   1. press the craft foam into the cutout to mark it, then cut the foam + glue in place (I use 3m spray glue)
3. Pressure fit the two magnets, one into the top and one the bottom
4. Screw the m3 screws into the hinge

That should do it! Good luck!